Instructions for the Iron-on Boot Camp Logo
  ===========================================

The manufacturer's instructions did not produce
   acceptable results, so I am including the
          instructions that I used.
 
1) Print the logo onto "iron-on transfer paper"
   from an inkjet printer.

2) Set up a pillow case folded in half on formica
   - no ironing board !!!

3) Set the iron to cotton, no steam, and let it
   warm up for 10 mins

4) Cut out printed logo with an 1/8" border, but
   leave a 1/2" border on one side that will be
   folded under for peeling off the backing 
   after ironing.

5) Position the T-shirt onto the pillow case, and
   place the printed logo face down.

6) Iron using heavy pressure for 2 full minutes
   moving slowly and constantly in a circular
   motion around the circumference of the logo.

7) Peel off the backing SLOWLY.

8) Perfection achieved !!!